Meccano Set Parts Lists

UK MECCANO SET PARTS LIST
Electrical Outfit X1 (1920-22)

Compiled by Timothy Edwards


 
 
Electrical Outfit X1 (1920-22)
Set P/N Modern P/N Part Description Quantity
301 181Bobbins 2
302 182Insulating brushes 12
303 1570/182aInsulating washers (also #1570) 12
304 15756 b.a.screw (also #1575) 14
305 15836 b.a. nut (also #1583) 30
306 1563Terminals (also #1563) 4
307 Contact screws 2
308 Pole pieces 2
309 Coil cheeks 2
310 183Lamp holder (also #183) 1
311 184cLamps 1
312 27 swg iron wire 1
313 26 swg SCC wire (50 yards) 1
314 23 swg SCC wire (25 yards) 1
315 Bare copper wire (4 yards) 1

NOTES

1. The 5 1/2" x 2 1/2" flanged plates initially had two flanges on the long sides. The four flanged version was announced in the May 1928 Meccano Magazine. Whilst these lists assume that this happened in 1928, this is not necessarily certain and there might well have been a delay whilst old stock was used up. This especially applies to sets for overseas. There is some evidence to suggest that the 1930 Outfit 000 had the two flanged version.

2. From 1927 to 1934 the 5 1/2" x 2 1/2" flanged plates (both two & four flanged versions) also had a sawcut and slot to accommodate the circular saw (Part No. 159).

3. Originally all bosses were single tapped. In 1926/7 all bosses became double tapped.