'Other' Constructional and Allied Systems Info & Downloads
Assemblo Construction Sets
Assemblo was an interesting construction toy similar to Meccano's Dinky Builder, only a little larger. It was produced in France from about 1930-1965.
Manufacturer / Distributor
S.G.D.G. France (Societe General de Genie), France
Info from the Metal Constructional Systems Database for ASSEMBLO
Maker
System Type
as DINKY BUILDER
as DINKY BUILDER
Country
France
France
Dates
1930 to circa 1965 (see comment *1)
1930 to circa 1965 (see comment *1)
Material
Steel
Steel
Thread
----
----
Boss Type
not tapped
not tapped
Boss Thread
----
----
Diametrical Pitch of Gears
--
--
No. of Parts in System
58
58
Hole Pitch (Spacing) (mm)
(see comment *2)
(see comment *2)
Diameter of holes in Strips(mm)
---
---
Diameter of the Bore in Bosses(mm)
3.2
3.2
Diameter of Axle Rods(mm)
3.0
3.0
Types of Nuts and Bolts
Nuts: --
Bolts: --
Nuts: --
Bolts: --
Material/Finish of Nuts and Bolts
-- --
-- --
Size of the Nuts across Flats (mm)
---
---
Bolt diameter (mm)
---
---
Comments
1st DINKY BUILDER-type system but more, larger parts. ASSEMBLO cast into Wheel parts; a few parts stamped ASSEMBLO Bte SGDG. *1 Possibly pre/postwar periods. *2 Hole only in centre of 'braced' Plate.
The MCS document for this system is shown below. It can also be downloaded to your computer if desired here
NOTE : If the MCS document does not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Below there are manuals/leafets and patents which can be downloaded by clicking on the appropriate image.
© 2010-2021 Timothy Edwards