'Other' Construction and Allied Systems Info & Downloads
Auto-Cycle Construction Sets
Auto-Cycle was an unusual set with special parts to mainly make bicycle models although other models were possible. It was made in France from around 1920-1930
Info from the Metal Constructional Systems Database for AUTO-CYCLE
Mainly Rods/Tubes and See comment *1()
known in 1920 to early 1930s
100 (more than)
3.1 (see comment *2)
3.5 (see comment *3)
--- (Screwed Rods or Bolts are used as axles.)
Bolts: See comment *4
Brass with a Brass finish
---(see comment *5)
Many special parts for (motor)cycles, 'planes, car, but other models including a Crane. *1 Aerospace+Road Vehicles. *2 In various parts. *3 3.0 in 25mm Pulley. *4*5 Hex Bolt may exist but only Nuts/Screwed Rods listed.
The MCS document for this system is shown below. It can also be downloaded to your computer if desired here
NOTE : If the MCS document does not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Below there are various manuals/leafets which can be downloaded by clicking on the appropriate image.
© 2010-2019 Timothy Edwards