'Other' Constructional and Allied Systems Info & Downloads
Benco Metall Baukasten Construction Sets
Benco Metall Baukasten was a construction system similar to Meccano. It had a few unusual parts. It was produced in Germany from around 1949 to 1960.
Manufacturer / Distributor
Berthold Neumann & Co. GmbH, Essen, Germany
Info from the Metal Constructional Systems Database for BENCO
Maker
System Type
Hole pitch <12.7mm
Hole pitch <12.7mm
Country
Germany
Germany
Dates
1949 to 1960s (some significant doubt)
1949 to 1960s (some significant doubt)
Material
Metal / Plastic
Metal / Plastic
Thread
M4
M4
Boss Type
not tapped
not tapped
Boss Thread
----
----
Diametrical Pitch of Gears
10 (see comment *1)
10 (see comment *1)
No. of Parts in System
77
77
Hole Pitch (Spacing) (mm)
12.5
12.5
Diameter of holes in Strips(mm)
4.5 (see comment *2)
4.5 (see comment *2)
Diameter of the Bore in Bosses(mm)
Diameter of Axle Rods(mm)
3.5 (see comment *3) (Screwed Rods or Bolts are used as axles.)
3.5 (see comment *3) (Screwed Rods or Bolts are used as axles.)
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: tapered cheese (slotted)
Nuts: hexagonal
Bolts: tapered cheese (slotted)
Material/Finish of Nuts and Bolts
Steel with a Nickel plated finish
Steel with a Nickel plated finish
Size of the Nuts across Flats (mm)
7.0
7.0
Bolt diameter (mm)
7.0
7.0
Comments
Some slightly unusual parts including large tooth Gears including combined Gear/Bevel. DIY plastic Plates from Sheets in 4 colours, & Tool to punch holes. *1 4.3-4.5 in other parts. *2 Mod.2.5. *3 Crank Shaft only.
The MCS document for this system is shown below. It can also be downloaded to your computer if desired here
NOTE : If the MCS document does not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Below there are manuals/leafets and photos which can be downloaded by clicking on the appropriate image.
© 2010-2021 Timothy Edwards