'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (804 systems found)

Construc Construction Sets

Construc was a construction system that used steel strips (with no holes) held together by special clips. It was made in the France in (probably) the late 1940s.

Manufacturer / Distributor

Agéco, Suresnes, France

Info from the Metal Constructional Systems Database for CONSTRUC

System Type
Non-Meccano type
before World War Two (some significant doubt) to 1950 (see comment *1)
Boss Type
Boss Thread
(see comment *2)
Diametrical Pitch of Gears
38 (see comment *3)
No. of Parts in System
35 (approximately)
Hole Pitch (Spacing) (mm)
Diameter of holes in Strips(mm)
Diameter of the Bore in Bosses(mm)
See comments *4
Diameter of Axle Rods(mm)
Types of Nuts and Bolts
Nuts: --

(see comment *5)
Material/Finish of Nuts and Bolts
Size of the Nuts across Flats (mm)
Bolt diameter (mm)
(see comment *6)

Parts held by Clips. These & Brackets are made from special Strips using Tool provided. compare with VULCAIN, EL MECANICO ARGENTINO. *1 & 46-50+ reported; name registered in 1947. *2--*3*4 Set Screw. *5 about. *6 varies.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided

There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.