Den Danske Ingeniør

Den Danske Ingeniør Construction Sets

Den Danske Ingeniør was a Meccano-like Construction system. It was produced in Denmark from the mid 1930s to ?.

Manufacturer / Distributor

An unknown company from Denmark

Info from the Metal Constructional Systems Database for DEN DANSKE INGENIØR

Maker

System Type
Hole pitch >12.7mm

Country
Denmark

Dates
1935 (some significant doubt)

Material
Steel

Thread
5/32W

Boss Type
single-tapped

Boss Thread
1/8W

Diametrical Pitch of Gears
14 (see comment *¹)

No. of Parts in System
93

Hole Pitch (Spacing) (mm)
13 (see comment *²)

Diameter of holes in Strips(mm)
4.4

Diameter of the Bore in Bosses(mm)
4.1

Diameter of Axle Rods(mm)
4.0

Types of Nuts and Bolts
Nuts: square
Bolts: cheese (slotted)

Material/Finish of Nuts and Bolts
Steel with a Brass finish

Size of the Nuts across Flats (mm)
6.3

Bolt diameter (mm)
5.6

Comments
Some Meccano-like parts, but many others including Curved Plates (4 to 2” circle), STABIL outline Gears, etc. Some MÄRKLIN parts in manual models. *¹ Mod 1.8, also about Mod 0.8. *² Most 12.9-13.0.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided

Below there are manuals/leafets and photos which can be downloaded by clicking on the appropriate image.

A Den Danske Ingeniør manual
(Added 14/11/2018)

Another very similar Den Danske Ingeniør manual
(Added 23/05/2019)

Various photos of the Den Danske Ingeniør construction system
(Added 14/11/2018)