'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (805 systems found)

Erector Skyscraper Construction Set

Erector Skyscraper was a construction system to make architectural buildings. Special card panels were fixed to a steel girder framework. It was made in the USA from 1935 to 1936.


Manufacturer / Distributor

The A.C. Gilbert Co., New Haven, Connecticut, USA


Info from the Metal Constructional Systems Database for ERECTOR SKYSCRAPER

Maker
Gilbert Erector
System Type
Buildings
Country
USA
Dates
1935 to 1936
Material
Steel / Card
Thread
8-32
Boss Type
no boss
Boss Thread
----
Diametrical Pitch of Gears
--
No. of Parts in System
7 (see comment *1)
Hole Pitch (Spacing) (mm)
12.7 (multiples of value shown, including half.)
Diameter of holes in Strips(mm)
4.2
Diameter of the Bore in Bosses(mm)
---
Diameter of Axle Rods(mm)
---
Types of Nuts and Bolts
Nuts: square
Bolts: round (slotted)Bolts: See comment *2
Material/Finish of Nuts and Bolts
 
Size of the Nuts across Flats (mm)
6.5
Bolt diameter (mm)
6.4

Comments
*1 Special card Panels which were held to frame of standard Angle Girders by Snap Rivets.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.