'Other' Construction and Allied Systems Info & Downloads

Kinema Construction Sets

Kinema was a simple construction system which used tubes with holes in them joined by special clips. It was produced in Germany from 1946 to the early 1950s


Info from the Metal Constructional Systems Database for KINEMA

Maker
 
System Type
Mainly Rods/Tubes
Country
Germany
Dates
circa 1946 to 1950 (some significant doubt)
Material
Steel
Thread
(see comment *1)
Boss Type
double-tapped (see comment *2)
Boss Thread
----
Diametrical Pitch of Gears
(see comment *3)
No. of Parts in System
68
Hole Pitch (Spacing) (mm)
10.0
Diameter of holes in Strips(mm)
1.5 (see comment *4)
Diameter of the Bore in Bosses(mm)
6.1
Diameter of Axle Rods(mm)
5.9
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: --
(see comment *5)
Material/Finish of Nuts and Bolts
 
Size of the Nuts across Flats (mm)
Bolt diameter (mm)
 

Comments
5.9mm Tubes with 1.5mm holes, joined by Unions/Split Pins. *1 Only Collar, Threaded Pin. *2 Holes for Pin, not tapped. *3 Sprockets (used as Gears?). *4 6.6 for Tubes; 1.5 for attaching parts. *5 For Threaded Pin.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


Below there are manuals/leafets and photos which can be downloaded by clicking on the appropriate image.


Kinema models for set 00
(Scans from Urs Flammer)

Kinema models for set 0
(Scans from Urs Flammer)

Some larger Kinema models
(Scans from Urs Flammer)

Various photos of the Kinema construction system
(Scans from Urs Flammer)