'Other' Constructional and Allied Systems Info & Downloads

Metallic Construction Sets

Metallic was a simple Meccano like construction system. It was made in France from around 1910 to 1918.

Info from the Metal Constructional Systems Database for MÉTALLIC

Maker
 
System Type
Hole pitch <12.7mm
Country
France
Dates
1913 (see comment *1)
Material
Steel
Thread
2.4x.6
Boss Type
tapped bore
Boss Thread
2.4x.6 (see comment *2)
Diametrical Pitch of Gears
--
No. of Parts in System
35
Hole Pitch (Spacing) (mm)
10.0 (see comment *3)
Diameter of holes in Strips(mm)
2.6 (mean)
Diameter of the Bore in Bosses(mm)
2.3 (see comment *4)
Diameter of Axle Rods(mm)
(Screwed Rods or Bolts are used as axles.)
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: hexagonal (slotted)
Material/Finish of Nuts and Bolts
Brass with a Brass finish
Size of the Nuts across Flats (mm)
` 
Bolt diameter (mm)
 

Comments
Similar WALTHER'S INGENIEUR but N&B & no wood parts. Strip(s), Angle Girders, 4 holes wide Perforated Plate(s) 3-10h long, & a large Fan. *1Probably short lived. *2In bore. *3Mean for Strip(s), 9.8-10.2 in some Plate(s). *4Thread's internal diameter.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided

Below there are various manuals/leafets which can be downloaded by clicking on the appropriate image.


The Metallic manual for set 2
(Added 18/10/2018)

Page content last updated - 18th October 2018