'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (816 systems found)

Miniatur Construction Sets

Miniatur was basically a smaller scale version of Stabil. It was made in Germany, from 1914 to 1938.


Manufacturer / Distributor

Walther & Co., Grünauerstr 8, Berlin SO.36, Germany


Info from the Metal Constructional Systems Database for MINIATUR

Maker
Walther
System Type
Hole pitch <12.7mm
Country
Germany
Dates
1914 to 1938
Material
Steel
Thread
1/8W (probably)
Boss Type
no boss
Boss Thread
----
Diametrical Pitch of Gears
--
No. of Parts in System
26
Hole Pitch (Spacing) (mm)
10.0
Diameter of holes in Strips(mm)
3.2
Diameter of the Bore in Bosses(mm)
---
Diameter of Axle Rods(mm)
--- (Screwed Rods or Bolts are used as axles.)
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: cheese (slotted)
Material/Finish of Nuts and Bolts
 
Size of the Nuts across Flats (mm)
5.8(see comment *1)
Bolt diameter (mm)
5.5(approximately)

Comments
2 sets from Walther with limited range of smaller scale STABIL-like parts. *1 Spanner jaw width.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.