'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (805 systems found)

Pa-Di-Ca-Co

Pa-Di-Ca-Co sets were purely made up of gears, that could be used with other systems. It was made in the UK, in the early 1920s.


Manufacturer / Distributor

The Patent Die-Casting Co. Ltd., Strode Road, Willesden, London NW1, UK


Info from the Metal Constructional Systems Database for PA-DI-CA-CO

Maker
 
System Type
DIY type
Country
United Kingdom
Dates
known in 1921
Material
Zinc (Alloy)
Thread
----
Boss Type
single-tapped
Boss Thread
8BA
Diametrical Pitch of Gears
40
No. of Parts in System
8
Hole Pitch (Spacing) (mm)
---
Diameter of holes in Strips(mm)
---
Diameter of the Bore in Bosses(mm)
4.1
Diameter of Axle Rods(mm)
---
Types of Nuts and Bolts
Nuts: --
Bolts: --
Material/Finish of Nuts and Bolts
--  --
Size of the Nuts across Flats (mm)
---
Bolt diameter (mm)
---

Comments
Gears Accessory Set probably aimed at MECCANO users, but Spur Gears reported to run at .93” centres & not the 1" implied from the claimed pcd's..

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.