'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (805 systems found)

Pajtás Construction Sets

Pajtás was a simple Meccano like construction system. They also did a set with special parts for electrical experiments. It was made in Hungary in around 1962.


Manufacturer / Distributor

Bacs-Kiscun, Megyet, Finommechanikai-Vallalat, Kecsckemet, Hungary


Info from the Metal Constructional Systems Database for PAJTÁS [b]

Maker
 
System Type
Hole pitch >12.7mm
Country
Hungary
Dates
known in 1966 (some significant doubt)
Material
Aluminium (Alloy)
Thread
M4
Boss Type
single-tapped
Boss Thread
M4
Diametrical Pitch of Gears
--
No. of Parts in System
26 (approximately)
Hole Pitch (Spacing) (mm)
13.0 (see comment *1)
Diameter of holes in Strips(mm)
4.2
Diameter of the Bore in Bosses(mm)
4.1
Diameter of Axle Rods(mm)
4.0
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: round (slotted)
(see comment *2)
Material/Finish of Nuts and Bolts
Steel with a Nickel plated finish
(see comment *3)
Size of the Nuts across Flats (mm)
6.8
Bolt diameter (mm)
6.7(see comment *4)

Comments
Lid has a boy & girl playing with 3 models. Some parts in common with the Electrical Set. *1 but 12.8 in 5x11h Flanged Plate. *2*3*4 Bolts slotted cheesehead plain steel 6.2 also possible.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided



Manufacturer / Distributor

Bacs-Kiscun, Megyet, Finommechanikai-Vallalat, Kecsckemet, Hungary


Info from the Metal Constructional Systems Database for PAJTÁS [a]

Maker
 
System Type
Electrical/science
Country
Hungary
Dates
circa 1962
Material
 
Thread
 
Boss Type
 
Boss Thread
 
Diametrical Pitch of Gears
--
No. of Parts in System
78
Hole Pitch (Spacing) (mm)
12.7 (some significant doubt)
Diameter of holes in Strips(mm)
 
Diameter of the Bore in Bosses(mm)
 
Diameter of Axle Rods(mm)
 
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: round (slotted)
Material/Finish of Nuts and Bolts
 
Size of the Nuts across Flats (mm)
Bolt diameter (mm)
 

Comments
Lid not seen. Standard parts including MÄRKLIN-type 5x11h Flanged Plate, 21 holes Angle Girder with all slotted holes, 7 holes Trunnion with side holes slotted. Dedicated parts incllude Motor Armature, Coil, Lamp Holder, Reflector, U Magnet.

NOTE - This system is covered in the MCS document above, so it is not repeated.

Below there are various manuals/leaflets which can be downloaded by clicking on the appropriate image.


A Pajtás manual
(Added 18/10/2018)