'Other' Constructional and Allied Systems Info & Downloads
Pajtás Construction Sets
Pajtás was a simple Meccano like construction system. They also did a set with special parts for electrical experiments. It was made in Hungary in around 1962.
See Pajtás(b) for the normal sets and Pajtás(a) for the electrical set.
Pajtás(b)
Manufacturer / Distributor
Bacs-Kiscun, Megyet, Finommechanikai-Vallalat, Kecsckemet, Hungary
Info from the Metal Constructional Systems Database for PAJTÁS [b] (Ref:PAJb)
Hole pitch >12.7mm
Hungary
known in 1966 (some significant doubt)
Aluminium (Alloy)
M4
single-tapped
M4
--
26 (approximately)
13.0 (see comment *1)
4.2
4.1
4.0
Nuts: hexagonal
Bolts: round (slotted)
(see comment *2)
Steel with a Nickel plated finish
(see comment *3)
6.8
6.7(see comment *4)
Comments
Lid has a boy & girl playing with 3 models. Some parts in common with the Electrical Set. *1 but 12.8 in 5x11h Flanged Plate. *2*3*4 Bolts slotted cheesehead plain steel 6.2 also possible.
The MCS document for this system is shown below. It can also be downloaded to your computer if desired here
NOTE : If the MCS document does not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Pages from the 'Other Systems Newsletter' which contain information on this system are shown below. They can also be downloaded to your computer if desired here
NOTE : If the 'Other Systems Newsletter' pages for PAJTÁS [b] do not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Pajtás(a)
Manufacturer / Distributor
Bacs-Kiscun, Megyet, Finommechanikai-Vallalat, Kecsckemet, Hungary
Info from the Metal Constructional Systems Database for PAJTÁS [a] (Ref:PAJa)
Electrical/science
Hungary
circa 1962
--
78
12.7 (some significant doubt)
Nuts: hexagonal
Bolts: round (slotted)
`
Comments
Lid not seen. Standard parts including MÄRKLIN-type 5x11h Flanged Plate, 21 holes Angle Girder with all slotted holes, 7 holes Trunnion with side holes slotted. Dedicated parts incllude Motor Armature, Coil, Lamp Holder, Reflector, U Magnet.
NOTE - This system is covered in the MCS document above, so it is not repeated.
NOTE - The 'Other Systems Newsletter' pages displayed further up this web page, may also include information on this system/era.
Below there are various manuals/leaflets which can be downloaded by clicking on the appropriate image.