'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (816 systems found)

Steel Tec Starters

Steel Tec Starters was a system similar to Steel Tec but aimed at younger children. It used plastic nuts and bolts and had larger holes in the strips and plates. It was made in the USA from at 1992 to circa 1996.


Manufacturer / Distributor

Remco Toys Inc., New York, USA


Info from the Metal Constructional Systems Database for STEEL TEC STARTERS

Maker
 
System Type
Meccano principle but sig. differences
Country
USA
Dates
1995
Material
Steel / Plastic
Thread
5.5x.3 (see comment *1)
Boss Type
push fit
Boss Thread
----
Diametrical Pitch of Gears
--
No. of Parts in System
100 (approximately)
Hole Pitch (Spacing) (mm)
12.7
Diameter of holes in Strips(mm)
6.0
Diameter of the Bore in Bosses(mm)
---
Diameter of Axle Rods(mm)
5.5 (see comment *2)
Types of Nuts and Bolts
Nuts: square
Bolts: cheese (crosshead)
(see comment *3)
Material/Finish of Nuts and Bolts
Plastic with a grey finish
Size of the Nuts across Flats (mm)
10.3
Bolt diameter (mm)
10.2

Comments
Many special plastic parts. *1 Square thread. *2 Plastic, some with plastic sleeves on 3mm steel. *3 Square recess.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.