'Other' Construction and Allied Systems Info & Downloads
Technical Trainer Construction Sets
Technical Trainer used rods held by couplings. It was made in the USA and known in 1946.
Info from the Metal Constructional Systems Database for TECHNICAL TRAINER
Maker
System Type
Mainly Rods/Tubes
Mainly Rods/Tubes
Country
USA
USA
Dates
known in 1946
known in 1946
Material
Aluminium (Alloy)
Aluminium (Alloy)
Thread
¼"-20
¼"-20
Boss Type
no boss
no boss
Boss Thread
----
----
Diametrical Pitch of Gears
--
--
No. of Parts in System
17
17
Hole Pitch (Spacing) (mm)
Variable
Variable
Diameter of holes in Strips(mm)
6.4 (approximately)
6.4 (approximately)
Diameter of the Bore in Bosses(mm)
6.3 (see comment *1)
6.3 (see comment *1)
Diameter of Axle Rods(mm)
6.4
6.4
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: hexagonal (slotted)
(see comment *2)
Nuts: hexagonal
Bolts: hexagonal (slotted)
(see comment *2)
Material/Finish of Nuts and Bolts
Steel with a Dull plated finish
Steel with a Dull plated finish
Size of the Nuts across Flats (mm)
11.1()(see comment *3)
11.1()(see comment *3)
Bolt diameter (mm)
11.1()(see comment *4)
11.1()(see comment *4)
Comments
Set aluminium seen; 'B' only in ad. ¼" Rods with threaded ends joined by Couplings. Large Bases. *1 Sample Wheel goes over thread but not smooth part of Rod. *2 Also acorn Nuts? *3*4 7/16" nominal.
The MCS document for this system is shown below. It can also be downloaded to your computer if desired here
NOTE : If the MCS document does not appear in the window below, then refresh the page.
The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided
Below there are manuals/leaflets and photos which can be downloaded by clicking on the appropriate image.
© 2010-2019 Timothy Edwards