'Other' Constructional and Allied Systems Info & Downloads

Select System Type      Select Country       (804 systems found)

The Engineer

The Engineer was a Meccano-like construction system. It was made in Canada in (probably) the 1940s.


Manufacturer / Distributor

The Engineer, 136 Adelaide Street West, Toronto, Canada
(Address for competition entries)


Info from the Metal Constructional Systems Database for THE ENGINEER

Maker
 
System Type
Meccano principle but sig. differences
Country
Canada
Dates
early 1940s (some significant doubt) to 1940s (some significant doubt)
Material
Steel
Thread
6-32 (see comment *1)
Boss Type
single-tapped
Boss Thread
6-32
Diametrical Pitch of Gears
--
No. of Parts in System
43 (more than)
Hole Pitch (Spacing) (mm)
12.7 (see comment *2)
Diameter of holes in Strips(mm)
5.0 (see comment *3)
Diameter of the Bore in Bosses(mm)
4.9
Diameter of Axle Rods(mm)
4.7
Types of Nuts and Bolts
Nuts: hexagonal
Bolts: round (slotted)
(see comment *4)
Material/Finish of Nuts and Bolts
Steel with a Dull plated finish
(see comment *5)
Size of the Nuts across Flats (mm)
7.9(see comment *6)
Bolt diameter (mm)
6.2(see comment *7)

Comments
Strips with raised edges; special pressed parts. *1 8-32 N&B also possible. *2 12.63-12.73. Also Strips with centre hole about 17.6mm from adjacent holes. *3 4.7-5.3. *4*5*6*7 For 8-32: square nut and slotted mushroom head bolt Nickel plated steel 9.7 8.3.

The MCS document for this system is shown below. It can also be downloaded to your computer if desired here

NOTE : If the MCS document does not appear in the window below, then refresh the page.

The report can be zoomed into, made full screen or downloaded as a pdf document by using the controls provided


There are currently no manuals, leaflets or photos etc. available for downloading. If you can supply any, please get in contact with me.